Xerox WorkCentre 5687 Series Service Manual page 1372

REP 11.19-170 BM Crease Roll Motor
Parts List on PL 11.86
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the rear cover, REP 11.1-170.
2. Remove 4 screws securing the BM PWB mounting plate to the frame, allow the PWB and
mounting plate to hang down, giving access to the BM crease roll motor.
3. Figure 1, remove the motor assembly.
Repairs/Adjustments
REP 11.19-170
1
Remove 3
screws
Figure 1 Motor assembly removal
Replacement
Reverse the removal procedure to replace the BM crease roll motor.
August 2007
4-352
5
Pull the motor
assembly off
the shaft
4
Remove the
encoder disc
3
Disconnect
the motor
harness
2
Remove the circlip
WorkCentre 5687 Family