Figure 2 Crimping the terminal
3.
Insert the wire fully into the terminal so that the stripped portion is within the inner grip of
the terminal. Close the crimp tool fully to make the crimp.
4.
Figure 3. Insert the crimped terminal into the appropriate position of the crimp tool and
close the crimp tool to fasten the wire insulation in the outer grip of the terminal.
Figure 3 Crimping the insulation grip
Repairs/Adjustments
REP 1.11
5.
Figure 4. Check that the crimp is correctly made.
Correct
Incorrect:
Loose strands of wire
Insulation in crimp
Wire exposed
Figure 4 Inspecting the finished crimp
6.
Insert the replacement terminal into the connector housing.
August 2007
4-26
WorkCentre 5687 Family