Xerox WorkCentre 5687 Series Service Manual page 1203

REP 10.8 Nip Split Shaft Assembly
Parts List on PL 10.11
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the output device and the right hand cover, PL 8.10 Item 9.
2. Remove the rear cover, PL 8.10 Item 1.
3. Remove the tie bar, Figure 1.
1
Remove 4 screws
2
Disconnect harness on
inverter motor driver
PWB
Figure 1 Tie bar
4. Remove the nip split shaft assembly, Figure 2.
WorkCentre 5687 Family
Replacement
Replacement is the reverse of the removal procedure. Refer to GP 6 before refitting the
screws.
1. Check that both springs are positioned correctly, Figure 3.
3
Remove the tie bar
August 2007
4-183
1
2
Release both springs
Remove nip split
shaft assembly
Figure 2 Nip split shaft assembly
Repairs/Adjustments
REP 10.8