2
Remove the two
E clips. One at
each end of the
shaft.
3
Remove two bearings. One at
each end of the shaft.
Figure 1 Preparation
5.
Figure 2, remove the diverter gate.
WorkCentre 5687 Family
1
Remove 2 screws, dis-
connect the harness
and remove the sole-
noid
1
Carefully push the
lever past the shaft
to rest against the
inner baffle
Replacement
Reverse the removal procedure to install the diverter gate.
August 2007
4-337
2
Push the diverter gate fully to
the rear
3
Carefully bend the centre of the diverter gate upwards and
remove
Figure 2 Diverter gate removal
Repairs/Adjustments
REP 11.9-170