Xerox WorkCentre 5687 Series Service Manual page 1635

1
Remove 2 springs. Lift
out the shaft complete
with nip rollers
2
Slide a nip roller along the shaft, apply grease to
the shaft and slide the nip roll back into position.
repeat for the other 3 nip rollers
Figure 21 5a and 5b nip roller lubrication
3. Re-install the top cover and upper left cover, REP 11.1-130 or REP 11.1-170.
WorkCentre 5687 Family
HCSS BM Inner Paper Path Nip Rollers
1. Remove the compiler carriage, REP 11.2-170.
2. Figure 22, use plastislip grease, PL 26.10 Item 8, to lubricate the inner paper path nip roll-
ers.
4
Repeat steps 1
2
to 3 for the 2
Slide a nip roller along the
remaining nip
shaft assemblies shaft, apply grease to the
shaft and slide the nip roll
back into position. repeat for
the other nip roller
3
Install the nip shaft assembly,
install the springs
3. Re-install the removed components.
August 2007
4-615
1
Pull a nip shaft
assembly out of the
locators
4
3
Repeat steps 1
Install the nip
to 3 for the
shaft assembly
remaining nip
under the
shaft assembly
spring
Figure 22 Nip roller lubrication
Repairs/Adjustments
ADJ 4.1