Xerox WorkCentre 5687 Series Service Manual page 1671

ADJ 11.1-130 Machine to HCSS Alignment
Parts List on PL 11.30
Purpose
To correctly align the HCSS to achieve reliable transfer of paper from the machine to the
HCSS.
Adjustment
Turn the hand wheels above the castors at the right of the HCSS to adjust the alignment:
• Figure 1, turn both hand wheels in the same direction to adjust the vertical alignment
between the HCSS and the machine viewed from the front or rear.
Figure 1 Machine to HCSS alignment
WorkCentre 5687 Family
ADJ 11.2-130 Hole Punch Position
Parts List on PL 11.36
Purpose
To optimize the position of the hole punch.
Check
1. Ask the customer which trays are used to feed from for hole punching.
2. Load the indicated trays with A4 (8.5x11 inch) paper.
3. Make a set of five punched copies or prints from each of the indicated trays. Mark the top
edge (towards the front of the machine) of each set to indicate the tray from which it was
fed.
4. Evaluate the average hole positions in each set, referring to Figure 1. The distances
shown should be equal at the top and bottom of the sheet. If the distances are different by
more than 1mm (0.040 inches), perform the adjustment.
Adjustment
1. Remove the chad bin, remove two thumb screws and the access cover and unscrew the
thumb screw retaining the hole punch assembly.
August 2007
4-651
Figure 1 Hole positions
Repairs/Adjustments
ADJ 11.1-130, ADJ 11.2-130