Xerox WorkCentre 5687 Series Service Manual page 1229

REP 11.3-110 Intermediate Paper Drive Belt
Parts List on PL 11.22.
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the 2K LCSS rear cover REP 11.1-110.
2. Remove the intermediate paper drive belt, Figure 1.
2
3
Disconnect PJ307.
Disconnect the bulkhead connector.
Figure 1 Removing the drive belt
Replacement
1. Lubricate the belt tensioner, refer to ADJ 4.1.
2. Install the belt over the pulleys, ensuring that the belt is on all five pulleys.
NOTE: Two of the pulleys are free to slide along the shaft. Ensure the belt is correctly
located on these pulleys.
3. Install the 2K LCSS rear cover, REP 11.1-110.
WorkCentre 5687 Family
REP 11.4-110 Paper Output Drive Belt and Paper Transport
Exit Motor
Parts List on PL 11.22.
Removal
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the 2K LCSS rear cover, REP 11.1-110.
2. Remove the intermediate drive belt, REP 11.3-110.
3. Remove the output drive belt and motor, Figure 1.
1
Disconnect the spring.
4
Remove the drive belt.
August 2007
4-209
WARNING
WARNING
Repairs/Adjustments
REP 11.3-110, REP 11.4-110