Xerox WorkCentre 5687 Series Service Manual page 1106

REP 7.4 Tray 3 and Tray 4 Elevator Cables
Parts List on PL 7.15
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
NOTE: The elevator drives at the front and at the rear are similar for both trays.
1. Remove tray 3 or tray 4, REP 7.2.
2. Remove the cables from the front drive pulley, Figure 1.
Figure 1 Front elevator cable removal
3. Remove the pulley carrier and pass the cables through the base of the tray, Figure 2.
Repairs/Adjustments
REP 7.4
2
Remove the short cable from the
drive pulley.
3
Remove the long cable from the
drive pulley.
1
Remove E clip
August 2007
4-86
NOTE: Short cable over the outer pulley and the long cable over the inner pulley.
Tray 4 pulley carrier
Tray 4 drive shaft
Remove cables
Figure 2 Remove front elevator cables
Tray 3 pulley
carrier
Tray 3 drive shaft
WorkCentre 5687 Family