Replacement
1.
Reverse the removal procedure to replace the hole punch unit, motor assembly and sen-
sors.
2.
If necessary, perform ADJ 11.3-110 Hole Punch Position.
NOTE: When installing the hole punch motor assembly, ensure that the belt tensioner arm
does not get trapped behind the motor assembly plate.
NOTE: Refer to IQS 6 Copy / Print Defects for hole punch performance specifications.
Repairs/Adjustments
REP 11.7-110, REP 11.8-110
REP 11.8-110 Stapler Traverse Assembly
Parts List on PL 11.20.
Removal
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Take care not to topple the 2K LCSS.
The 2K LCSS is unstable when un-docked from the machine.
Do not show the customer how to un-dock the 2K LCSS.
1.
Un-dock the 2K LCSS, REP 11.13-110.
2.
Remove the rear cover and front door cover assembly, REP 11.1-110.
3.
Manually move the ejector, PL 11.18 Item 1 fully to the right.
4.
Figure 1, Disconnect the harness.
NOTE. For clarity the entry guide cover is omittedy
Figure 1 Harness disconnection
August 2007
4-216
WARNING
WARNING
WARNING
1
Disconnect the group
of 5 connectors.
WorkCentre 5687 Family