Xerox WorkCentre 5687 Series Service Manual page 1142

3
Press the rear lug over the post
4
Remove the transport
1
Remove 2 screws
2
Apply pressure between
transport and tray
Figure 2 Tray 3 transport assembly
Replacement
Replacement is the reverse of the removal procedure. Refer to GP 6 before refitting the
screws.
Repairs/Adjustments
REP 8.13, REP 8.14
REP 8.14 Tray 3 Feed Sensor Actuator
Parts List on PL 7.15
Removal
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove tray 3 transport assembly, REP 8.13.
2. Remove tray 3 feed sensor actuator, Figure 1.
NOTE: Make a note of how the spring is located.
1
Remove the actuator
Figure 1 Tray 3 feed sensor actuator
Replacement
Replacement is the reverse of the removal procedure.
Take care when locating the actuator spring, it can be easily deformed or broken
August 2007
4-122
WARNING
WARNING
2
Remove actuator spring
CAUTION
WorkCentre 5687 Family