Xerox WorkCentre 5687 Series Service Manual page 1333

REP 11.37-130 Entry Sensor and Punch Position Sensor
Parts List on PL 11.38
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the rear cover and upper left cover, REP 11.1-130.
2. If installed, remove the hole punch unit, PL 11.36 Item 12.
3. Remove the lower left cover, PL 11.30 Item 22.
4. Remove the sensor cover, PL 11.38 Item 11.
5. Figure 1, remove the sensor.
WorkCentre 5687 Family
2
Move the front of the tie
bar to the right and
release the rear from the
dowels
Figure 1 Sensor removal
Replacement
Reverse the removal procedure to replace the entry sensor and punch position sensor.
August 2007
4-313
1
Remove
3 screws
4
Remove screw and sensor,
disconnect the harness
3
Rotate the assembly
to access the screws
Repairs/Adjustments
REP 11.37-130