Xerox WorkCentre 5687 Series Service Manual page 1284

Figure 2 Compiler carriage supports
NOTE: The motor worm and wheel are greased, wear disposable gloves, PL 26.10 Item 10
during this step to avoid grease contamination.
4. Rotate the compiler carriage elevator motor worm by hand to release the tension on the
elevator belts
5. Remove the rear elevator belt tensioner spring, REP 11.8-130.
6. Figure 3, remove the compiler carriage elevator motor.
Repairs/Adjustments
REP 11.6-130
NOTE: Bin 0 and bin
1 have been omitted
for clarity
1
Hook the top of the compiler
carriage supports into the
screw holes
2
Hook the bottom of the com-
piler carriage supports
under the black plastic cross
member
7. Figure 4, remove the motor from the bracket.
August 2007
4-264
4
Remove 3 screws
3
Disconnect the harness
2
Remove worm wheel
and E-clip behind the
worm wheel
1
Remove E-clip
Figure 3 Motor and bracket removal
NOTE: Bin 1 has
been omitted for clar-
ity
5
Remove the motor
assembly and bearing
WorkCentre 5687 Family