Table of Contents
Advertisement
REP 11.30-171 BM Tamper Assembly and Tamper 1 Motor
Parts List on PL 11.162
Purpose
This procedure is used to repair the following components:
•
BM tamper 1 motor, PL 11.162 Item 3.
•
BM rear tamper arm, PL 11.162 Item 5.
•
BM front tamper arm, PL 11.162 Item 6.
•
BM rear tamper rack, PL 11.162 Item 7.
•
BM front tamper rack, PL 11.162 Item 8.
•
BM rear tamper assembly, PL 11.162 Item 9.
•
BM front tamper assembly, PL 11.162 Item 10.
•
BM tamper gear,PL 11.162 Item 11.
•
BM tamper bracket, PL 11.162 Item 12.
•
BM tamper rack guide, PL 11.162 Item 13.
•
BM tamper guide plate, PL 11.162 Item 15.
•
BM rear tamper finger, PL 11.162 Item 16.
•
BM front tamper finger, PL 11.162 Item 17.
Removal
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1.
Open the HVF BM front door and fully pull out the BM module.
2.
Remove the crease blade knob (6d), PL 11.161 Item 4.
3.
Remove the crease roll handle (6c), PL 11.161 Item 5.
4.
Remove the BM front cover, PL 11.161 Item 3.
5.
Remove the left frame plate, PL 11.163 Item 17.
WorkCentre 5687 Family
6.
Figure 1, remove the tamper assembly.
2
If necessary, remove 2
screws to remove the
motor
6
Move the tampers to align with the
slots to release each tamper from the
slot
7
Remove the tamper
assembly
Figure 1 Tamper assembly removal
August 2007
4-481
3
4
Remove 2 screws
Remove 2 screws
and earth connector
1
5
Remove the cover and
Remove 2 screws
disconnect the harness
Repairs/Adjustments
REP 11.30-171
Hide quick links:
Advertisement
Chapters
Table of Contents
