Xerox WorkCentre 5687 Series Service Manual page 1168

REP 8.31 Tray 3 and Tray 4 Transport Roll
Parts List on PL 8.30
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove tray 3 and tray 4 transport motor, REP 8.10.
2. Remove Tray 3 and tray 4 transport drive gear, REP 8.11.
3. Remove the left cover, PL 7.25 Item 2.
4. Remove paper tray 2, REP 7.1.
5. (32-55 ppm Only) Remove the ground plate, Figure 1.
Figure 1 Remove the ground plate (32-55 ppm only)
Repairs/Adjustments
REP 8.31
6. Remove tray 3, REP 7.2.
7. Remove the idler shaft assembly, Figure 2.
1
Remove 2 screws
and the bracket
2
Remove the ground
plate
3
Remove the E-clip
2
Remove the idler rolls, shaft and
bearings
August 2007
4-148
1
Remove the springs
Figure 2 Remove the idler shaft assembly
WorkCentre 5687 Family