Xerox WorkCentre 5687 Series Service Manual page 1318

REP 11.27-130 Transport Motor 2 and Motor Damper
Parts List on PL 11.48
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the carriage PWB, but only disconnect sufficient PWB connectors to allow
access to the motor screws, refer to REP 11.4-130.
2. Figure 1, remove transport motor 2.
Repairs/Adjustments
REP 11.27-130
1
Loosen screw,
move tensioner
fully upward,
tighten screw
3
Remove the motor
3. Remove 2 nuts to separate the motor damper from the motor.
Replacement
1. Reverse the removal procedure to replace transport motor 2.
2. Ensure that the ground connector is secured with the lower motor screw, Figure 1.
3. Figure 1, loosen the tensioner screw, allow the spring to tension the belt, then tighten the
tensioner screw, ADJ 11.3-130.
August 2007
4-298
2
Remove 2 screws
Figure 1 Motor removal
WorkCentre 5687 Family
Ground
connector