Xerox WorkCentre 5687 Series Service Manual page 1665

ADJ 11.1-110 2K LCSS Bin 1 Level
Parts List on PL 11.10
Purpose
To ensure bin 1 is level, and achieve the best stacking performance.
Adjustment
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the bin 1 motor, refer to REP 11.5-110.
2. Move bin 1 to the lowest position.
3. Slacken the screw on each belt clamp and adjust the position they sit on the belts to level
the tray. Lock the clamps.
4. Re-install the bin 1 motor, refer to REP 11.5-110.
5. Switch on the machine, GP 14.
6. Enter dC330 code 11-033, Bin 1 Elevator Motor Cycle. Check that bin 1 cycles without
giving any fault indications.
WorkCentre 5687 Family
ADJ 11.2-110 Machine to 2K LCSS Alignment
Parts List on PL 11.2
Purpose
To correctly align the 2K LCSS to achieve reliable transfer of paper from the machine to the 2K
LCSS.
Adjustment
Turn the hand wheels above the castors below bin 1 to adjust the alignment:
• Figure 1, turn both hand wheels in the same direction to adjust the vertical alignment
between the 2K LCSS and the machine viewed from the front or rear.
Figure 1 Machine to 2K LCSS alignment
August 2007
4-645
Repairs/Adjustments
ADJ 11.1-110, ADJ 11.2-110