Replacement
Refer to GP 6 before refitting the screws.
1.
Bias the entry guide cover away from the paper guide when you tighten the screws.
2.
The clearance between the entry guide cover and the paper guide must be a minimum of
1 mm. Refer to Figure 2.
NOTE: If the clearance is less than 1 mm, then install a new entry guide cover.
Figure 2 Entry guide cover clearance
3.
Run copies through the output device, if possible use heavy weight paper or labels.
Check for marks on the print and for damage to the paper. If there are no marks or dam-
age then install the covers.
Repairs/Adjustments
REP 11.13-120
Check for a minimum
clearance of 1mm
between the entry
guide cover and the
paper guide
August 2007
4-246
WorkCentre 5687 Family