REP 11.33-130 Docking Latch Components
Parts List on PL 11.34
Purpose
This procedure is used to repair the following components
•
Docking Release latch, PL 11.34 Item 13.
•
Release bracket, PL 11.34 Item 11.
•
Docking interlock switch (S11-300A), PL 11.34 Item 3.
•
Docking pivot interlock switch (S11-300B), PL 11.34 Item 5.
•
Restraining cable, PL 11.34 Item 1.
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1.
Un-dock the HCSS from the machine, REP 11.19-130.
2.
Figure 1, release the restraining cable.
WorkCentre 5687 Family
Figure 1 Restraining cable
3.
Figure 2, remove the docking latch bracket rear cover.
August 2007
4-307
4
Open the bracket
as far as possible
1
Release the latch, open
the bracket fully
2
Remove screw
3
If a new restraining
cable is being installed,
remove screw
Repairs/Adjustments
REP 11.33-130