Xerox WorkCentre 5687 Series Service Manual page 1245

REP 11.14-110 2K LCSS PWB
Parts List on PL 11.26
Removal
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the 2K LCSS rear cover assembly, REP 11.1-110.
2. Disconnect all harness connectors from the 2K LCSS PWB.
3. Remove the three screws and release the three standoffs securing the 2K LCSS PWB.
Replacement
NOTE: Before replacing the 2K LCSS rear cover assembly, perform 11F-110 2K LCSS PWB
DIP Switch Settings RAP.
Reverse the removal procedure to replace the 2K LCSS PWB.
WorkCentre 5687 Family
REP 11.15-110 Entry Guide Cover
Parts List on PL 11.24
Removal
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the 2K LCSS front cover and 2K LCSS rear cover, REP 11.1-110.
2. Disconnect the harness to the entry sensor, PL 11.24 Item 3, at the rear frame.
3. Figure 1, remove the entry guide cover.
August 2007
4-225
WARNING
WARNING
Repairs/Adjustments
REP 11.14-110, REP 11.15-110