Table of Contents
Advertisement
11-100-171, 11-101-171 HVF Entry Sensor RAP
11-100-171 The paper leading edge is late arriving at the entry sensor.
11-101-171 The paper trailing edge is late leaving the entry sensor.
Initial Actions
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
•
Check for a jam or other obstruction in the entrance guide.
•
Check the entrance guide for damage.
Procedure
Figure 1. shows the location of the components.
Enter dC330, code 11-100. Manually operate the entry sensor, Q11-100, Figure 1. The
play changes.
Y
N
Go to Flag 1. Check the sensor, Q11-100.
Refer to:
•
GP 11 How to Check a Sensor.
•
P/J101, HVF Control PWB
•
11A-171 HVF Power Distribution RAP
Install new components as necessary:
•
Entry sensor, PL 11.156.
•
HVF Control PWB, PL 11.157 Item 2.
Enter dC330, code 11-000 to run the Entry feed motor 1, MOT 11-000, Figure 1. The
runs.
Y
N
Go to Flag 2. Check the entry feed motor 1, MOT 11-000.
Refer to:
•
GP 10 How to Check a Motor.
•
P/J102, HVF Control PWB
•
11A-171 HVF Power Distribution RAP
Install new components as necessary:
•
Entry feed motor 1, PL 11.150 Item 12
•
HVF control PWB, PL 11.157 Item 2.
Check the drive belt on the motor. The drive belt is good.
Y
N
Install a new drive belt, PL 11.150 Item 13.
The fault may be intermittent, check for damaged wiring or bad connectors, REP 1.2. If neces-
sary install new components:
•
Entry sensor, PL 11.156
WorkCentre 5687 Family
•
Entry feed motor 1, PL 11.150 Item 12.
•
HVF control PWB, PL 11.157 Item 2.
dis-
Entry feed motor 1
(MOT11-000)
Entry sensor
(Q11-100)
motor
Figure 1 Component location
August 2007
2-557
Status Indicator RAPs
11-100-171, 11-101-171
Hide quick links:
Advertisement
Chapters
Table of Contents
