Xerox WorkCentre 5687 Series Service Manual page 1288

1
Pull the belt out of
the front belt grip
Figure 5 Release the belts from the carriage
9. Remove the compiler carriage elevator motor, REP 11.6-130.
10. Figure 6, release the rear belts from the top pulley.
Repairs/Adjustments
REP 11.7-130
2
Pull the belt out of the
rear belt grip
11. Figure 7, remove the rear elevator belt.
August 2007
4-268
1
Mark the position of the small
belt on the pulley
2
Slide the small belt off the pul-
ley and slowly release the ten-
sion to the mylar guide system.
Lay the mylar guide over the
input baffle
3
Slide the large belt off the pulley
Figure 6 Releasing belts
WorkCentre 5687 Family