Xerox WorkCentre 5687 Series Service Manual page 1562

REP 11.74-171 TF Roller Assembly and Diverter Solenoid
Parts List on PL 11.197
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Undock the Tri-Folder assembly from the HVF (see REP 11.73-171). Position and support
the Tri-Folder so that it is safely accessible from the front, rear and left side.
2. Release the crease roll drive belt tension (See REP 11.69-171). Disconnect the diverter
and entry gate solenoid PJs.
NOTE: First remove the lower front and rear screws. Support the roller assembly and
remove the upper front and rear screws. If not supported the assembly will fall inside the
Tri Folder frame.
3. Disconnect the paper sensor PJ and remove the Tri Folder roller assembly through the
front door, Figure 1.
Repairs/Adjustments
REP 11.74-171
Rear
Screws
Figure 1 Tri Folder Roller Assembly
4. Remove the diverter gate solenoid and crease roll pulleys as required, Figure 2.
Replacement
Reverse the removal procedures to reinstall the pulleys, diverter gate solenoid and Tri Folder
roller assembly.
Before replacing the roller assembly set the diverter operating lever to the forward (solenoid
armature extended) position to engage with the right side of the diverter shaft lever, Figure 2.
August 2007
4-542
Paper
Sensor
Front
Screws
WorkCentre 5687 Family