Xerox WorkCentre 5687 Series Service Manual page 1503

REP 11.31-171 HVF Buffer Guide Assembly
Parts List on PL 11.153
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the HVF front door, REP 11.1-171.
2. Remove the HVF top cover, REP 11.1-171.
3. Remove the HVF front cover, REP 11.1-171.
4. Remove the HVF rear cover, REP 11.1-171.
5. Figure 1. At the rear of the finisher, disconnect the two PJs.
REAR VIEW
Figure 1 Disconnecting PJs.
WorkCentre 5687 Family
6. Figure 2. Remove the pivot screw.
7. Pass the PJs through the cut-out in the rear frame.
8. Withdraw the guide through the front opening.
Replacement
Disconnect the
two PJs
Position the spigot at the guide rear in the hole in the rear frame. The rest of the replacement
procedure is the reverse of the removal procedure.
August 2007
4-483
Remove the
pivot screw
Figure 2 Pivot screw removal.
Repairs/Adjustments
REP 11.31-171