Xerox WorkCentre 5687 Series Service Manual page 1037

2
Remove terminal from housing
1
Insert a paper clip to
release prong
Figure 2 Terminal removal; female housing.
2. Cut off the damaged terminal, then strip 3mm of insulation from the end of the wire.
WorkCentre 5687 Family
Replacement
1. Table 1. Select the correct replacement terminal and identify the appropriate crimp posi-
tions for the terminal. Refer to PL 31.18 Item 1.
Table 1 Connector Information
Description Part No
Male socket 115P60155
Female pin 115P60182
2. Figure 3. Insert the terminal into the appropriate position of the crimp tool and close the
tool enough to hold the terminal.
Figure 3 Crimping the terminal.
3. Insert the wire completely into the terminal, so that the stripped portion of the wire is in the
longer grip of the terminal. The insulation of the wire is within the cable grip of the termi-
nal. Close the crimp tool completely to make the crimp. Check that the wire is crimped
firmly in the terminal.
August 2007
4-17
Extractor Crimp Tool Crimp Tool Jaw
Wire Insulation
- 600T913 A B
Paper clip 600T913 A B
Repairs/Adjustments
REP 1.5