Xerox WorkCentre 5687 Series Service Manual page 1300

1
Engage spring in
hook of guide reel
Figure 9 Spring location
5. Install the following components by reversing the removal procedure:
• Mylar guide reel assembly.
• Belt drive.
• Mylar guide reel bearings.
6. Figure 10, set the position of the mylar guide to correctly tension the torsion spring.
Repairs/Adjustments
REP 11.13-130
2
Slide the gear on the shaft and
engage spring in slot
August 2007
Figure 10 Spring tension
7. Figure 11, Connect the mylar guide to the compiler carriage.
4-280
1
Slide the small belt off
the pulley
3
Slide the small belt
on the pulley
2
Rotate the mylar guide drum
using the belt until the free end
of the mylar guide aligns with
the step in the frame
WorkCentre 5687 Family