Xerox WorkCentre 5687 Series Service Manual page 950

Table 11 11-5XX Status codes
Status
Code UI Message Reason for Message
11-948 Clear the paper jam in the Sheet detected near the tri-fold
Tri-Folding Unit assist sensor
11-949 Finisher Insert Stock Out of An insert sheet has not arrived
Order at its intended output destina-
tion
11-950 Unexpected Stock Size in A shorter than expected sheet
the Finisher has been fed from the inserter
11-951 Clear the paper jam in the Sheet detected near the stacker
finisher bin exit sensor
Table 12 12-5XX Status codes
Status
Code UI Message Reason for Message
12-530 Offsetting is unavailable. Offsetting catch tray is not in
Check for obstructions in index position.
the output tray
Table 13 14-5XX Status codes
Status
Code UI Message Reason for Message
14-508 System error, scanner is Status active when start is
unavailable selected but scan service is
unable to acquire resources
Status Indicator RAPs
OF4a
Status
Reference / Action Code UI Message
Clear the sheet. If 14-560 Scanner is calibrating,
necessary, perform please wait
11-185-171 to 11-187-
171 RAP
See the message
text. If necessary, per-
form 11-191-171, 11-
193-171, 11-194-171,
11-196-171 RAP and
11-100-171, 11-101-
171 RAP
Follow the message
14-561 No message
text. Check the size of
the paper in the
inserter.
Clear the sheet. If
necessary, perform
11-140-171, 11-142-
171 RAP
14-562 Adjustments in progress
Reference / Action
Perform 12-301 RAP
14-563 Scanner has failed to initai-
ilize. Switch off the
machine, wait 1 minute,
then switch on the
machine. If fault persists
Reference / Action
call for assistance, or press
close to use other services
Switch off the
machine then switch 14-564 No message
on the machine, GP
14. Wait for a few min-
utes, if scanning is still
not available, go to
03-330, 03-462 RAP
August 2007
2-758
Table 13 14-5XX Status codes
Reason for Message Reference / Action
Scanner is calibrating If calibration does not
complete, switch off
the machine, then
switch on the
machine, GP 14. Wait
for a few minutes, if
the scanner contin-
ues to calibrate with-
out completing
perform 14-703 to 14-
706, 712, 714, 716,
718 RAP
Downloaded NVM values are Switch off the
out of range and too low. SVCM machine, then switch
received NVM data within cor- on the machine, GP
rect range 14. Wait for a few min-
utes, if scanning is still
not available perform
03-330, 03-462 RAP
Scanner ready checks are not If the ready check
complete does not complete,
switch off the
machine, then switch
on the machine, GP
14. Wait for a few min-
utes, if the scanner
continues to check
without completing
perform 03-330, 03-
462 RAP
Scanner needs service Switch off the
machine then switch
on the machine, GP
14. Perform 14-110
RAP, 14-310, 14-710
RAP, 14-720 RAP
Job is incomplete, scan ser- Resume the scanning
vice is ready and needs a job, or press the can-
resume command cel key. If the status
code is still present,
switch off the
machine, then switch
on the machine, GP
14
WorkCentre 5687 Family