Xerox WorkCentre 5687 Series Service Manual page 1309

3
Loosen two
screws on
the motor
bracket
Figure 2 Belt removal
4. Disconnect the motor harness if necessary.
5. Remove 2 screws to remove the motor from the motor damper.
Replacement
1. Reverse the removal procedure to replace the drive belt.
2. Loosen the belt tensioner screw, allow the belt tensioner to tension the belt, ADJ 11.3-
130.
WorkCentre 5687 Family
REP 11.19-130 HCSS Un-Docking
2
Removal
Remove the pulley
Do not show the customer how to un-dock the HCSS.
1. Release the jam clearance latch and fully open the gap between the machine and the
1
HCSS.
Remove the
2. Figure 1, move the HCSS away from the machine
K-L clip
5
Remove the
drive belt from
the pulleys
4
Slide the
motor and
bracket
off the
screws
3. Disconnect the harnesses between the machine and the HCSS if necessary.
Replacement
Reverse the removal procedure to replace the HCSS.
August 2007
4-289
CAUTION
2
Roll the HCSS away
from the machine
1
Feel under the docking latch
bracket and release the docking
latch by pulling the lever forward
Figure 1 Docking latch location
Repairs/Adjustments
REP 11.18-130, REP 11.19-130