Xerox WorkCentre 5687 Series Service Manual page 1274

Replacement
Reverse the removal procedure to replace the compiler carriage assembly, referring to the fol-
lowing list:
1. Use the compiler carriage supports to support the compiler carriage during the replace-
ment.
2. Ensure that the compiler is aligned as shown in Figure 8.
Belt tensioner
springs must be 50
+/- 10 mm (2 +/- 0.5
inches) below the
bottom of the belt
grips
Figure 8 Carriage alignment
Repairs/Adjustments
REP 11.2-130
3.
4.
5.
Top of both grips must align with
marks on the frame
August 2007
4-254
If necessary the elevator belt tensioner springs can be repositioned, refer to REP 11.8-
130.
Remove the compiler carriage supports.
Figure 9, ensure the mylar guide is correctly located.
WorkCentre 5687 Family