Xerox WorkCentre 5687 Series Service Manual page 1385

Figure 1 Actuator removal
4. Temporarily attach the PWB mounting plate using only the top two screws.
5. Open the HCSS BM front door and fully pull out the BM module.
6. Remove the crease blade knob (6d), PL 11.80 Item 4.
7. Remove the crease roll handle (6c), PL 11.80 Item 5.
8. Remove the BM front cover, PL 11.80 Item 3.
9. Remove both staple head covers, PL 11.88 Item 14.
10. Figure 2, lower the stapler bracket.
WorkCentre 5687 Family
2
Remove
the KL-clip
3
Remove the
actuator
1
Remove the
sensor 2
Pull the stapler bracket
handle to open the staplers
fully
11. Figure 3, remove the latch shaft.
August 2007
4-365
1
Release the rear follower
from the slot using a
screwdriver
Figure 2 Lowering stapler bracket
Repairs/Adjustments
REP 11.28-170