Xerox WorkCentre 5687 Series Service Manual page 1271

1
Release the tension of the mylar guide
3
Carefully allow the mylar
guide to be rolled upwards
by the spring
Figure 3 Mylar guide release
8. Remove the compiler carriage support springs from the base of the HCSS. Figure 4,
install the compiler carriage supports.
WorkCentre 5687 Family
2
Move the metal end of
the mylar guide
towards the front and
unhook from the hole
in the compiler car-
riage frame
9. Figure 5, remove the clamp.
10. Figure 6, release the compiler carriage assembly from the frame.
August 2007
4-251
1
Hook top of the compiler
carriage supports into the
screw holes
2
Hook the bottom of the
compiler carriage sup-
ports under the black
plastic cross member
Figure 4 Compiler carriage supports
Remove screw and clamp
Figure 5 Clamp removal
Repairs/Adjustments
REP 11.2-130