Xerox WorkCentre 5687 Series Service Manual page 1537

REP 11.58-171 BM Crease Nip Springs
Parts List on PL 11.165
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Open the BM front door and fully pull out the BM.
2. Rotate the crease roll handle (6c) fully counterclockwise.
3. Remove the crease blade knob (6d), PL 11.161 Item 4.
4. Remove the crease roll handle (6c), PL 11.161 Item 5.
5. Remove the BM front cover, PL 11.161 Item 3.
WorkCentre 5687 Family
6. Figure 1, remove the front lower linkage.
3
Release the linkage from
the spring hook
Figure 1 Front linkage removal
August 2007
4-517
1
Remove the
KL-clip
2
Slide the linkage off the shafts
Repairs/Adjustments
REP 11.58-171