Xerox WorkCentre 5687 Series Service Manual page 820

C
• P/J601 HVF control PWB.
• 11A-171, HVF BM Power Distribution RAP.
Install new components as necessary:
• Bin1 90% full sensor, Q11-331, PL 11.135 Item 3.
• HVF control PWB, PL 11.157 Item 2.
Lower the bin 1 tray by pressing the PTU switch, or by entering the dC330 code 11-032, bin1
elevator motor down. Enter the dC330 code 11-196, bin 1 rear wall sensor. Actuate the bin 1
rear wall sensor using a sheet of paper. The display changes.
Y N
Go to Flag 8.Check the wiring and repair as necessary, REP 1.2. Check the bin 1 rear
wall sensor, Q11-196. Refer to:
• GP 11 How to Check a Sensor.
• P/J403 on the HVF control PWB.
• 11A-171, HVF BM Power Distribution RAP.
Install new components as necessary:
• Bin 1 rear wall sensor, Q11-196, PL 11.140 Item 17.
• HVF control PWB, PL 11.157 Item 2.
Perform SCP 6 Final Actions.
Status Indicator RAPs
11-460-171 to 11-462-171
Bin 1 rear wall sensor,
Q11-196
Bin 1 home sensor,
(receiver) Q11-332
Bin 1 home sensor,
(transmitter)
Bin 1 upper limit
switch, S11-334
Bin 1 90% full sensor, Q11-331
Bin 1 lower limit
switch, S11-335
Figure 1 Component location
August 2007
2-628
Bin 1 encoder
Bin 1 lift
sensor, Q11-182
motor,
MOT11-030
WorkCentre 5687 Family