Table of Contents
Advertisement
REP 11.1-130 HCSS Covers
Parts List on PL 11.30
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
NOTE: All major HCSS covers are dealt with in this procedure, only remove the covers listed in
the procedure that you are performing.
1.
Figure 1, remove the top cover.
2
Remove 2 screws
1
Pivot the top tray.
Remove 2 screws
4
Remove the top cover.
Figure 1 Top cover removal
2.
Figure 2, remove the rear cover.
WorkCentre 5687 Family
2
Remove 4 screws
3.
To remove the front door, remove the lower hinge pin and slide the door from the upper
pivot pin, refer to PL 11.30.
4.
To remove the front cover, remove 6 screws, refer to PL 11.30 Item 7.
3
5.
To remove the hole punch access cover, remove 2 thumb screws, PL 11.30 Item 2.
Disconnect PJ493
6.
To remove the upper left cover, PL 11.30 Item 1, remove two screws.
and PJ439
Replacement
Reverse the removal procedure to install the HCSS covers.
NOTE: If the compiler carriage is in the fully raised position, the safety gate on the top cover
will need to be raised by hand when top cover is installed.
August 2007
4-249
3
4
Remove one screw
Remove the rear
cover
1
Remove the harness from
the retainer.
Figure 2 Rear cover removal
Repairs/Adjustments
REP 11.1-130
Hide quick links:
Advertisement
Chapters
Table of Contents
