Xerox WorkCentre 5687 Series Service Manual page 1561

Top Cover
Clip
Pivot Shaft
Pivot Shaft
Screw
Figure 2 Top Cover Removal
3. Remove the screws holding the base. Release the springs and remove the idler assem-
blies, Figure 3.
WorkCentre 5687 Family
Pivot Shaft
Screw
Front Frame
Torsion Spring
August 2007
Figure 3 Cover Base and Idler Assembly
Replacement
Reverse the removal procedures to reinstall the top cover idler assemblies and top cover.
Make sure that the correct self-tapping screws are used to replace the cover base; do not over-
tighten, GP 6.
Replace, but do not tighten, the rear pivot shaft screw. Position the cover and torsion spring
then fit the front of the pivot shaft in the frame. Replace and tighten both front and rear pivot
shaft screws.
Check that the cable harnesses are not obstructed or touching moving parts when the Tri-
Folder is docked to the HVF.
4-541
Top Cover
Retaining Spring
Idler Assembly
Base
Repairs/Adjustments
REP 11.73-171