Xerox WorkCentre 5687 Series Service Manual page 1331

REP 11.35-130 Bin 1 or Bin 2 Offset Motor and Offset
Sensor
Parts List on PL 11.52, PL 11.54
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the bin 1 or bin 2 tray assembly by disconnecting the harness, removing the
thumbscrew and pulling the tray assembly off the support.
2. Figure 1, remove the bin lower support.
1
Remove 4 screws
Figure 1 Support removal
3. Figure 2, remove the bin offset sensor and bin offset motor.
WorkCentre 5687 Family
2
Remove the bin lower support
August 2007
1
Pinch the sensor legs together, remove the
sensor and disconnect the harness
Figure 2 Component removal
Replacement
Reverse the removal procedure to replace the bin 1 or bin 2 offset motor and offset sensor.
NOTE: Ensure the peg of the gear/crank locates in the slot of the tray.
4-311
2
Remove 1 E-clip
and gear/crank
3
Remove 1 E-clip
and the gear
4
Remove 2 screws
and the motor
5
Disconnect the motor
harness
Repairs/Adjustments
REP 11.35-130