Xerox WorkCentre 5687 Series Service Manual page 1467

REP 11.7-171 Pressing Plate Fingers
Parts List on PL 11.140
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the right side-cover REP 11.5-171.
2. Remove the screws and lower the fingers through the cover slots, Figure 1.
Front Pressing
Plate Finger
Figure 1 Pressing Plate Fingers
Replacement
Reverse the removal procedures to replace the front and rear pressing plate fingers.
WorkCentre 5687 Family
Rear Pressing
Plate Finger
REP 11.8-171 Front and Rear Support Fingers
Parts List on PL 11.140
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the right side cover REP 11.5-171.
2. Remove the ejector assembly REP 11.7-171.
3. Remove the ejector front plate and support finger assembly, Figure 1.
Front Tamper Base.
Figure 1 Ejector Front Plate
August 2007
4-447
WARNING
WARNING
Ejector front plate
Repairs/Adjustments
REP 11.7-171, REP 11.8-171