Xerox WorkCentre 5687 Series Service Manual page 1016

IQS 5 Skew
Documents
Test patterns: 82E2000 (A3 and 11X17) 82E2010 (A4) 82E2020 (8.5X11).
Specification
Refer to Table 1, Skew measurement.
Table 1 Skew measurement
Source of paper DADH
All trays lead edge registration 3mm (1/8 inch) 1.3mm (1/16 inch)
Bypass tray 3mm (1/8 inch) 1.3mm (1/16 inch)
Duplex 3mm
Skew measurement
The amount of skew is determined by the difference, "A" from "B" Figure 1, measured from the
datum line to the lead edge of the print or copy. The distance between area "A" and area "B" is
250mm (10 inches). Use internal test prints 16 or 17 to check printer skew.
Corrective Action
Refer to IQ1 Image Quality Entry RAP.
Image Quality RAPs
IQS 5
Document glass Printer
1mm (1/32 inch)
1mm (1/32 inch)
1.3mm (1/16 inch) 1mm (1/32 inch)
August 2007
3-26
Measure from this datum line to the edge
of the print.
Measure from this datum line to the
edge of the print.
Figure 1 Skew measurement
WorkCentre 5687 Family
Area A
Area B