Xerox WorkCentre 5687 Series Service Manual page 1264

7. Figure 2, remove the 1K LCSS.
2
Use the lifting handles to
remove the 1K LCSS from
the mounting bracket.
Docking latch (front
and rear)
Figure 2 1K LCSS removal
Replacement
The replacement is the reverse of the removal procedure. Ensure that the bottom bracket on
the 1K LCSS is located over the support pins. Line up the 1K LCSS latches to the machine
apertures then push the two units firmly together until they latch.
Repairs/Adjustments
REP 11.11-120, REP 11.12-120
1
Slide the 1K LCSS away from the
machine to disengage the latches and
bottom bracket.
Support pins (front and
rear)
Bottom bracket
August 2007
4-244
REP 11.12-120 1K LCSS PWB
Parts List on PL 11.124.
Removal
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the 1K LCSS rear cover, REP 11.1-120.
2. Disconnect all harness connectors from the 1K LCSS PWB.
3. Remove the three screws and release the three standoffs securing the 1K LCSS PWB.
Replacement
Reverse the removal procedure to replace the 1K LCSS PWB. Before replacing the 1K LCSS
rear cover, perform the 11F-120 1K LCSS PWB DIP Switch Settings RAP.
WorkCentre 5687 Family