REP 9.8 Transfer / Detack Harness
Parts List on (32-38 ppm) PL 9.22, (45-87 ppm) PL 9.20
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1.
Remove the short paper path assembly, REP 10.1.
2.
Remove the Transfer / Detack harness, Figure 1.
1
Insert a screwdriver to flex the
frame
2
Push down on the harness
terminal block to release the
Tab on the harness terminal block
tab
Figure 1 Transfer / detack harness
Replacement
Replacement is the reverse of the removal procedure.
WorkCentre 5687 Family
REP 9.9 Erase Lamp
Parts List on (32-38 ppm) PL 9.22, (45-87 ppm) PL 9.20
Removal
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1.
Remove the fuser module, PL 10.10 Item 1.
2.
Remove the xerographic module, PL 9.20 Item 2.
3.
Remove the erase lamp support, Figure 1.
Figure 1 Erase lamp support
4.
Remove the erase lamp, Figure 2.
August 2007
4-167
WARNING
WARNING
1
Remove the screw
2
Pull out the erase
lamp support
Repairs/Adjustments
REP 9.8, REP 9.9