Xerox WorkCentre 5687 Series Service Manual page 1158

5. Remove the feed sensor, Figure 4.
1
Disconnect the harness.
Figure 4 Remove the feed sensor
Repairs/Adjustments
REP 8.24
Replacement
1. Replacement is the reverse of the removal procedure. Refer to GP 6 before refitting the
screws.
2. (55-87 ppm Only) Before refitting the left hand door cover, ensure that the wait sensor
harness is correctly located. Refer to Figure 3.
3. Ensure that the lug on the cover is located correctly in the left hand door assembly, Figure
5.
2
Remove 1 screw,
then the sensor.
August 2007
4-138
2
Location point on
the door assembly
1
Lug on the cover
Figure 5 Location of the cover
WorkCentre 5687 Family