Table of Contents
Advertisement
Registration Transport Gears
Parts list on: PL 8.15.
1.
Remove the registration clutch, REP 8.5.
2.
Use plastislip grease, PL 26.10 Item 8, to lubricate the following parts:
•
Registration clutch, PL 8.15 Item 7. Lubricate the gear teeth only.
•
Gear (22T/28T), PL 8.15 Item 17. Lubricate the gear teeth only.
•
Gear (23T), PL 8.15 Item 18. Lubricate the gear teeth and the bore of the gear.
3.
Re-install the removed components, REP 8.5.
Developer Assembly Main Drive Gear
Parts list on: PL 9.15 Item 16.
NOTE: Only perform this lubrication if a new main drive gear is being installed.
1.
Remove the developer assembly, REP 9.2.
2.
Remove the old main drive gear (1 E-clip).
3.
Use plastislip grease, PL 26.10 Item 8, to coat the area of the main drive shaft, where the
gear locates.
4.
Install the new main drive gear (1 E-clip).
Developer Module Support Pins
1.
Remove the developer assembly, REP 9.2.
2.
Figure 4, use plastislip grease, PL 26.10 Item 8, to lubricate the developer assembly sup-
port pins at the front and rear.
WorkCentre 5687 Family
Front pins
Figure 4 Developer assembly support pins
3.
Re-install the developer assembly, REP 9.2.
August 2007
4-605
Rear pins
Repairs/Adjustments
ADJ 4.1
Hide quick links:
Advertisement
Chapters
Table of Contents
