Hcss Bm Crease Roll Gate Failure Rap - Xerox WorkCentre 5687 Series Service Manual

11-415-170 HCSS BM Crease Roll Gate Failure RAP

11-415-170 The HCSS crease roll gate is not at the home position.
Initial Actions
• Check for a jam or other obstruction that can prevent the crease roll gate mechanism from
moving.
• Check the following parts for damage:
– Crease roll gate rack gears, PL 11.87 Item 8.
– Crease roll gate racks, PL 11.87 Item 14.
Procedure
Enter dC330 code 11-415. Actuate the BM crease roll gate home sensor, Q11-415. The
play changes.
Y N
Go to Flag 1, check the BM crease roll gate home sensor, Q11-415, Figure 1.
Refer to:
• GP 11, How to Check a Sensor.
• P/J552, BM PWB.
• 11C-170 HCSS BM Power Distribution RAP.
Install new components as necessary:
• BM PWB, PL 11.86 Item 10.
• BM crease roll gate home sensor PL 11.86 Item 9.
Enter dC330, code 11-401 to run the BM crease roll gate motor, MOT 11-401, Figure 1. The
motor runs.
Y N
Go to Flag 2 and Flag 3, check the BM crease roll gate motor, MOT 11-401.
Refer to:
• GP 10 How to Check a Motor.
• P/J555, BM PWB.
• 11C-170 HCSS BM Power Distribution RAP.
Install new components as necessary:
• BM PWB, PL 11.86 Item 10.
• BM crease roll gate motor, PL 11.86 Item 8.
The fault may be intermittent, check for damaged wiring or bad connectors, REP 1.2. If neces-
sary install a new BM PWB, PL 11.86 Item 10.
Status Indicator RAPs
11-415-170
dis-
Figure 1 Component location
August 2007
2-516
BM crease roll gate home sensor,
Q11-415
BM crease roll gate motor,
MOT 11-401
WorkCentre 5687 Family