Tire Pressure Monitoring System - Subaru LEGACY 2006 Manual

asieps_tobira.book 11 ページ ２００９年１０月２６日 月曜日 午前９時１６分
7. Tire Pressure Monitoring
System
A: REMOVAL
1. TRANSMITTER (TIRE PRESSURE SEN-
SOR)
1) Remove the wheels from the vehicle. <Ref. to
WT-6, REMOVAL, Steel Wheel.>
2) Bleed air from tire valve.
3) Remove the nut, and drop the transmitter in the
tire.
(4)
(1) Transmitter
(2) Nut
(3) Wheel
(4) Tire
(5) Push
4) Remove the tires from wheels.
CAUTION:
Use a tire changer when removing the tire from
the wheel.
5) Remove the nut to take out transmitter.
NOTE:
Replace the grommet with a new part when reusing
transmitter.

Tire Pressure Monitoring System

(5)
(2)
(1)
(3)
WT-00098
WT-11
WHEEL AND TIRE SYSTEM
2. TIRE PRESSURE MONITORING CON-
TROL MODULE
1) Remove the driver's seat. <Ref. to SE-9, RE-
MOVAL, Front Seat.>
2) Turn up the floor mat in the driver's seat area.
3) Remove the connector to remove tire pressure
monitoring control module.
B: INSTALLATION
1. TRANSMITTER (TIRE PRESSURE SEN-
SOR)
1) Install the transmitter to the wheel by aligning it
with valve hole, and then tighten with nuts.
(1) (2)
(4) (1)
(1) Transmitter
(2) Grommet
(3) Nut
(4) Wheel
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.53 ft-lb)
WT-00073
(3)
(4)
(2) (3)
WT-00072