Subaru LEGACY 2006 Manual page 4284

asieps_tobira.book 11 ページ ２００９年１０月２６日 月曜日 午前９時１６分
VDC Sequence Control
VEHICLE DYNAMICS CONTROL (VDC)
4. VDC Sequence Control
A: OPERATION
1) While the VDC sequence control is performed,
the operation of the hydraulic unit can be checked
using the brake tester or pressure gauge after the
hydraulic unit solenoid valve is operated.
2) VDC sequence control can be started by Subaru
Select Monitor.
1. VDC SEQUENCE CONTROL WITH SUB-
ARU SELECT MONITOR
NOTE:
In the event of any trouble, sequence control will
not operate.
1) Connect the Subaru Select Monitor to data link
connector under the driver's side instrument panel
lower cover.
2) Turn the ignition switch to ON.
3) Set the Subaru Select Monitor switch to ON.
4) Set the Subaru Select Monitor to "Brake Control"
mode.
5) When the "VDC Inspection Mode" is selected
from the "Function check sequence" menu, the
"VDC sequence control" will start.
6) "Press the [YES] key" will be displayed. Press
the YES key.
7) Operation points will be displayed on Subaru Se-
lect Monitor.
VDC-11