Wheel Balancing - Subaru LEGACY 2006 Manual

asieps_tobira.book 9 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4) Install the selected weight to the point designat-
ed by the wheel balancer.
CAUTION:
• Degrease the wheel surface where the adhe-
sive type weight will be applied.
• Press the adhesive type weight by 25 N (2.5
kgf, 5.6 lb) or more per 5 g (0.18 oz) for more
then two seconds and attain full adhesion.
• Total application of the adhesive type weight
should be 100 g (3.53 oz) or less.
• The total weight of all adhesive weight on
models with transmitters (tire pressure sensor)
is to be 120 g (4.23 oz) or less.
5) Using the wheel balancer, measure the wheel
balance again. Check that wheel balance is cor-
rectly adjusted.
NOTE:
Knock-on type balance weights for aluminum
wheels can be used on any 15 to 18-inch aluminum
wheels.
A
(1) Knock-on type weight for aluminum wheel
(2) Knock-on type weight for steel wheel
Service limit A:
Knock-on type weight for steel wheel:
5 — 25 g (0.18 — 0.88 oz) 2.0 mm (0.08 in)
30 g (1.06 oz) or more 1.8 mm (0.07 in)
Knock-on type weight for aluminum wheel:
5 — 25 g (0.18 — 0.88 oz) 5.0 mm (0.20 in)
30 g (1.06 oz) or more 4.5 mm (0.177 in)

Wheel Balancing

A
WT-00006
WT-9
WHEEL AND TIRE SYSTEM