Subaru LEGACY 2006 Manual page 4277

asieps_tobira.book 16 ページ ２００９年１０月２６日 月曜日 午前９時１６分
VEHICLE DYNAMICS CONTROL (VDC)
6. Steering Angle Sensor
A: REPLACEMENT
CAUTION:
• Do not perform the removal except when the
replacement.
• When replacing more than three times, re-
place the combination switch as assembly to
protect the threads.
1) Set the steering wheel in a straight-ahead posi-
tion.
2) Disconnect the ground cable from battery.
3) Remove the airbag module.
<Ref. to AB-17, REMOVAL, Driver's Airbag Mod-
ule.>
WARNING:
Always refer to "Airbag System" when perform-
ing the airbag module repair service.
<Ref. to AB-6, CAUTION, General Description.>
4) Remove the steering wheel.
<Ref. to PS-14, REMOVAL, Steering Wheel.>
5) Remove the screws and remove the steering
column lower cover.
6) Remove the two screws securing the steering
column upper cover.
7) Unlock the harness band and disconnect the
connector of the steering angle sensor.
(1) Harness band
(2) Connector
8) Remove the screws which secure the roll con-
nector to steering column.
Steering Angle Sensor
9) Remove the steering angle sensor from roll con-
nector.
10) Turn the protrusion portion of new steering an-
gle sensor to match the alignment mark of inspec-
tion hole.
(1) Protrusion portion
(2) Inspection hole
(3) Alignment mark
CAUTION:
Be careful not to allow foreign matter to enter
( 1 ) into inspection hole.
11) Align the center of roll connector.
<Ref. to AB-26, INSTALLATION, Roll Connector.>
( 2 )
12) Apply a thin coat of grease that is supplied with
VDC00093
the new part, to the 4 protruding sections of the
steering angle sensor.
(1) Apply grease.
VDC00207
VDC-16
VDC00208
(2)
(3)
VDC00209
ABS00435
(1)
(1)