Subaru LEGACY 2006 Manual page 4302

asieps_tobira.book 5 ページ ２００９年１０月２６日 月曜日 午前９時１６分
2. Tire
A: INSPECTION
1) Take stones, glass, nails etc. out of the tread
groove.
2) Replace tires in the following cases.
CAUTION:
• When replacing a tire, make sure to use only
tires of the same size, construction and load
range as originally installed.
• Use a tire changer when removing the tire
from the wheel.
• On models equipped with tire pressure mon-
itoring systems, do not use the bead breaker in
a 90° area centered on the transmitter to pre-
vent damaging the transmitter.
(1)
(1) Transmitter
(2) 90° (use of a bead breaker is prohibited in this
area.)
• To prevent damaging the transmitter, set the
tire changer boom in the position as shown in
the figure.
(2)
(1)
(1) Transmitter
(2) Direction of turn table rotation
(3) 90°
(4) Tire changer boom
(1) If large cracks on side wall, damage or
cracks on the tread is found.
Tire
(2)
WT-00070
(4)
(3)
WT-00071
WT-5
WHEEL AND TIRE SYSTEM
(2) When the "tread wear indicator" appears as
a solid band across the tread.
(1) Tread wear indicator
(2) Tire tread
3) When a crack on tire valve is found, replace the
tire valve.
1. TIRE ROTATION
Rotate the tires periodically (12,500 km/7,500
miles) as shown in the figure, in order to prevent
them from uneven wear and to prolong their life.
• Without instruction for the direction of tire rotation
1
(1) Front
• With instruction for the direction of tire rotation
1
(1) Front
NOTE:
Vehicles equipped with tire pressure monitoring
systems will require re-registration of transmitter
ID. <Ref. to TPM(diag)-9, REGISTER TRANSMIT-
TER ID, OPERATION, Subaru Select Monitor.>
WT-00002
WT-00113
WT-00115