Subaru LEGACY 2006 Manual page 4290

asieps_tobira.book 12 ページ ２００９年１０月２６日 月曜日 午前９時１６分
WHEEL AND TIRE SYSTEM
2) Install the tires to wheels.
CAUTION:
• Use a tire changer when installing tire to
wheel.
• To prevent damaging the transmitter, set the
tire changer boom in the position as shown in
the figure.
(2)
(1)
(1) Transmitter
(2) Direction of turn table rotation
(3) 90°
(4) Tire changer boom
3) Install the wheels to vehicle. <Ref. to WT-6, IN-
STALLATION, Steel Wheel.>
4) Register the transmitter ID to the tire pressure
monitoring control module. <Ref. to TPM(diag)-9,
REGISTER TRANSMITTER ID, OPERATION,
Subaru Select Monitor.>
2. TIRE PRESSURE MONITORING CON-
TROL MODULE
Install in the reverse order of removal.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
C: ADJUSTMENT
Re-register the transmitter ID when transmitter has
been replaced or tires have been rotated. <Ref. to
TPM(diag)-9, REGISTER TRANSMITTER ID, OP-
ERATION, Subaru Select Monitor.>
Tire Pressure Monitoring System
(4)
(3)
WT-00071
WT-12