Toyota Tundra 2005 Service - Repair - Maintenance page 2230

CL−6
CLUTCH −
REMOVAL
1. REMOVE FILLER CAP AND FLOAT FROM RES-
ERVOIR
2. DRAW OUT BRAKE FLUID WITH SYRINGE
NOTICE:
Do not let brake fluid remain on a painted surface. If brake
fluid spill onto a painted surface, wash it off immediately.
3. DISCONNECT CLUTCH LINE FROM MASTER CYL-
INDER
Using SST, disconnect the clutch line. Use a container to catch
the fluid.
SST
4. REMOVE CLIP AND CLEVIS PIN
(a) Using needle−nose pliers, remove the clip.
SST
(b) Remove the clevis pin and wave washer.
D06510
5. REMOVE 2 MOUNTING NUTS AND PULL OUT MAS-
TER CYLINDER
6. REMOVE GASKET
D04399
CLUTCH MASTER CYLINDER
09023−00101
CL082−02