Toyota Tundra 2005 Service - Repair - Maintenance page 2241

B
A
CLUTCH − CLUTCH UNIT
INSPECTION
1. INSPECT CLUTCH DISC FOR WEAR OR DAMAGE
Using calipers, measure the rivet head depth.
Minimum rivet depth: 0.3 mm (0.012 in.)
If necessary, replace the clutch disc.
CL0239
2. INSPECT CLUTCH DISC RUNOUT
Using a dial indicator, check the disc runout.
Maximum runout: 0.7 mm (0.027 in.)
If necessary, replace the clutch disc.
CL0373
3. INSPECT FLYWHEEL RUNOUT
Using a dial indicator with a roller instrument, check the flywheel
runout.
Maximum runout: 0.1 mm (0.004 in.)
If necessary, replace the flywheel.
Q07250
4. INSPECT DIAPHRAGM SPRING FOR WEAR
Using calipers, measure the diaphragm spring for depth and
width of wear.
Maximum
Depth A: 0.5 mm (0.020 in.)
Width B: 6.0 mm (0.236 in.)
If necessary, replace the clutch cover.
Z10062
5. INSPECT CLUTCH RELEASE BEARING
Turn the bearing by hand while applying force in the axial direc-
tion.
HINT:
The bearing is permanently lubricated and requires no cleaning
or lubrication.
If necessary, replace the release bearing.
D13776
CL−17
CL0EU−01